9.9
Modelling snow interception and unloading in the Canadian Land Surface Scheme
Paul A. Bartlett, Environment Canada, Toronto, ON, Canada; and M. MacKay, N. Neumann, D. Verseghy, and A. G. Barr
The ability of forest canopies to intercept snow influences the amount of snow accumulated in the snowpack and the forest water balance. Intercepted snow held aloft in the canopy is more exposed to the wind while snow that falls to the forest floor, either as throughfall or after unloading from the canopy, is sheltered and is less likely to sublimate. It is therefore useful to determine whether the length of time that snow is held in the canopy is an important consideration in the modelling of forest-snow interaction and the forest water balance. While the development of interception and unloading algorithms has been advanced by monitoring changes in the mass of artificial and cut trees suspended in canopies, there is a scarcity of stand-level data from which the rates of snow interception and unloading can be assessed. Above-canopy albedo data encompass a larger spatial sample and have also been used to derive unloading timescales for boreal jack pine and black spruce stands.
In this study we make use of a series of digital photographs taken using cameras mounted on towers at the BERMS (Boreal Ecosystem Research and Monitoring Sites) Old Black Spruce (OBS) and Old Jack Pine (OJP) sites, along with meteorological data, to derive relationships between the rate of change in the intercepted snow mass (I) and coverage (Fsnow) and local weather conditions. The new interception and unloading algorithms are employed in the Canadian Land Surface Scheme (CLASS) Version 3.3 and the modelled snow water equivalent (SWE), and albedo are compared with observations, and with simulations employing algorithms used in previous versions of CLASS.
The results show that interception algorithms from early versions of CLASS benefited from a fortuitous offsetting of errors, with the effects of a small interception capacity, offset by a lack of unloading. Subsequent algorithms offering incremental improvements to specific aspects of the interception and unloading processes do not always show improved agreement between the model and observations because errors no longer offset one another. Increasing the interception capacity (I*) suppressed the range in modelled albedo because Fsnow is modelled as I/I*. Initial estimates of the timescale of the unloading process were too long; the e-folding time was initially set to 10 days but analysis of above canopy albedo and photographs showed that 1-2 days was more appropriate. At OBS, total incoming radiation was the most important variable for modelling the unloading rate, followed by global solar radiation and air temperature. At OJP, air temperature was the most important variable, followed by total incoming radiation and wind speed. Initial implementations of an unloading rate modelled based on meteorological conditions did not show an obvious improvement over a time-based unloading rate. Canopy photographs also showed that modelling Fsnow as I/I* results in an underestimate because of the widespread coverage that results from new snow. Employing a polynomial of the average relationship derived from photographs improved the modelled albedo. Modelled SWE is sensitive to whether or not unloading takes place, to large changes in the unloading rate and to the interception capacity, but is less sensitive to the parameters used to model the unloading rate.
Recorded presentationSession 9, Atmospheric Modeling and Data Assimilation of Land-Surface Climate Interactions
Thursday, 1 May 2008, 1:30 PM-3:15 PM, Floral Ballroom Jasmine
Previous paper