Recorded presentation1B.3
Field measurements from a new carbon dioxide and methane eddy-covariance flux analyzer for terrestrial, sea, and airborne applications
Randy Apodaca, Picarro, Inc., Sunnyvale, CA; and B. Law, A. Karion, C. Thomas, C. Sweeney, E. Crosson, T. A. Rahn, and W. McGillis
It is clear that a comprehensive understanding of the impact of climate change on local and global weather patterns still requires much more data, namely, mapping the atmospheric mixing ratios (concentrations) of carbon dioxide (CO2) and methane (CH4). Moreover, even as this understanding becomes more complete, there will also be a major ongoing need to continuously map quantitative levels of these gases to monitor the effects of regional, national and international green house gas (GHG) reduction efforts, as well as to certify compliance. To carry out this effort will require analyzers that can produce continuous, parts-per-billion precision, high accuracy measurements of ambient levels of atmospheric gases at very high data rates over years of operation in land-based, sea-based, as well as aircraft-based applications. A challenge worth considering is to create a single analyzer that can address the GHG measurement needs of virtually all these applications. Such an analyzer would be required to produce slow time-response (e.g. minute to minute data is considered very fast time response), and very high accuracy (which can also be described as precision across a network of independent measurements) as required for atmospheric monitoring and some mobile applications as well as fast time-response (e.g. 1 Hz to 10 Hz) and excellent relative precision (without the need for long-term accuracy, or comparability of mixing ratios across multiple sites) as needed for eddy covariance flux measurements. Such an analyzer would give the research community much more flexibility, a wider choice of research applications, reduce overall capital equipment cost, and improve the inter-comparability of GHG measurements across applications.
Picarro, Inc. has developed a high speed Cavity Ring-Down Spectroscopy (CRDS) based analyzer, able to measure carbon dioxide (CO2) concentration to a precision (one standard deviation) of 250 parts-per-billion (ppbv), and methane (CH4) concentration to a precision of 2 ppbv, both at up to 10-Hertz (Hz) quasi-simultaneously with extremely high accuracy. In collaboration with researchers from the University of Colorado, Oregon State University, Los Alamos National Laboratory, and Columbia University the performance of this newly developed analyzer was quantified while operating under different field conditions. In this work, measurements showing the exchange of both CO2 and CH4 between terrestrial ecosystems and the atmosphere, the exchange of CO2 and CH4 across the air-sea interface, and the recording of CO2 and CH4 mixing ratios of ambient air while aboard a research aircraft will be shown.
Session 1B, Particulate and Trace Gas Exchanges
Monday, 2 August 2010, 1:30 PM-3:00 PM, Crestone Peak III & IV
Previous paper Next paper